ISO INTERNATIONAL STANDARD 13934-1 Secondedition 2013-04-15 Textiles Tensile properties of fabrics - Part 1: Determination of maximum force and elongation at maximum force using the strip method Textiles-Proprieétés des étoffes en traction- Partie 1: Détermination de la force maximale et de I'allongement a la force maximale par la méthode sur bande Reference number ISO 13934-1:2013(E) ISO CoyrhtInationarganizatiofrStandardizaio @ IS0 2013 ed without license from IHS Not for Resale IS0 13934-1:2013(E) COPYRIGHT PROTECTED DOCUMENT @IS02013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved Not for Resale IS0 13934-1:2013(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions ..1 4 Principle ..3 5 Sampling. 6 Apparatus ..4 6.1 CREmachine .4 7 Atmosphere for conditioning and testing ..5 8 Preparation of test specimen ..5 8.1 General, .5 8.2 Dimensions. .5 8.3 Preparation of test specimens .5 8.4 Wet test specimens. .6 6 Procedure. .6 9.1 Gauge length .6 9.2 Rate of extension or elongation. .6 9.3 Mounting of test specimens. .6 9.4 Operation. .7 9.5 Tests on wet test specimens. 10 Calculation and expression of results 11 Test report. Annex A (informative) Suggested procedure for sampling ..10 Annex B (informative) Locations of test specimens cut from a laboratory sample .11 Bibliography ..12 ii vithout license from IHS Not for Resale